Instar IN-6001HD Bedienungsanleitung Seite 23

01 - Microphone
02 - Photosensor
03 - Lens
04 - Infrared LEDs
05 - MicroSD Card Slot
06 - Loudspeaker
07 - Network Port
08 - Power Connector
09 - Camera Label
10 - WPS / Reset
11 - Status LED
12 - Mount
4.3. Status LEDs
Status LED
Constant on
Slow Flashing
Fast Flashing
Off
Go to http://install.instar.com
For noise detection / audio rec. / two-way audio intercom
Twilight switch for IR LEDs
Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
4 IR LEDs (nightvision @ 850nm)
Slot for MicroSD/SDHC cards (max. 32GB - 8GB included)
Integrated loudspeaker
RJ45 LAN-port / connector for Cat5e LAN cable or higher
LED: orange, green (please refer to below chapter 4.3)
5V / 1.5A DC - Plug Ø : 1.35mm (in) / 3.5mm (out)
P2P ID, LAN MAC address and serial number
3 seconds for quick WiFi setup / 15-20 seconds for reset
blue: network status (can be turned on/off)
Please refer to below Chapter 4.3 Status LED
For standing, wall mount and overhead installation
(1/4"-20 UNC)
Blue LED
Booting process
or in operation
LAN connection
WiFi connection
Firmware update
in process or
LED is turned off
Green LED
-
-
Data transfer
through LAN
No network cable
connected or in
WiFi mode
Orange LED
Network cable is con-
nected or in WiFi mode
-
-
Network cable is not
connected correctly
6-EN