Additional Function; Changing The Tool - Kress 800 FME Originalbetriebsanleitung

40974_BA_FME_1603.book Seite 20 Mittwoch, 2. März 2016 5:51 17
20 English

Additional function

Continuous electronic control (Option)
EN
The continuous electronic control
keeps the speed almost constant
under no-load and under load and
ensures uniform performance.
Electronic control (Option)
In the event of overload or overheating
during continuous operation, the speed
is automatically reduced until the
machine has cooled sufficiently.
Soft starter
The starting current limitation reduces the starting
current. The motor revs up slowly until it reaches
the preselected rotational speed. This can extend
the service life of the machine.
Electronic overload protection
With a load that is too high, which therefore
implies a risk to the motor, the rotational speed of
the milling motor is reduced by the integrated
monitoring of the motor. The machine must be
released (preferably remove it a short distance
from the workpiece) to ensure that you can have
full capacity again.
Operation
The tool runs on for a short time after
it is switched off.
If there is contact between the tool and
the support surface, there is a danger
of losing control of the machine.
Switching On and Off
To switch on the machine, push the On/Off switch
5 forward and press it down at the front to lock on.
To switch off the machine, press down the On/Off
switch 5 at the rear so that the switch springs back
to the off position.
Preselect speed (Option)
In devices with a setting dial 6, you can select the
speed using the setting dial 6 depending on the
area of application.
FME-EN / 1603
800FME/800FME-Q/
1050FME
1
-1
10.000 min
2
-1
12.600 min
3
-1
17.000 min
4 -1
21.000 min
5
-1
25.000 min
6 -1
29.000 min

Changing the tool

Disconnect the plug from the power
source before making any adjust-
ments, changing accessories, or stor-
ing power tools.
Such preventive safety measures pre-
vent accidental start of the power tool.
Wear safety gloves for tool changing.
The tool insert can become very hot
after working for long periods and/or
the cutting edges of the tool insert
are sharp.
Clamping the tools
The spindle 3 of the milling and grinding motor is
equipped with a precision collet chuck 2 to hold
the tools. A spindle lock enables you to tighten
and loosen the locknut 1.
 To clamp the tool, you lock the spindle 3 by
pressing the locking button 4.
 You tighten the locknut 1 using a SW 17 open-
ended spanner.
 When you unclamp the tool, the spindle 3 in
turn is locked.
 You loosen the locknut 1 by turning the open-
ended spanner. You can remove the tool by
continually turning the open-ended spanner.
Attention! After you use the insertion
tool, perform a test run with an over-
speed and make sure that no-one is
within reach of the rotating insertion
tool. Damaged tools usually break in
this test period.
Operation
1050FME-1/
1050FME-P
-1
5.000 min
-1
7.700 min
-1
12.500 min
-1
16.500 min
-1
21.000 min
-1
25.000 min