RODIA
bearing guide rollers for precise and easy
cutting feed.
Cooling system
The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade. A drain hole, with a plug, is
located in the water container. Mud flaps
prevent most of the water mist and make
sure most water flows back in the water
container.
6. UNPACKING AND SET UP
Setting up
• Unpack the sawing machine and
inspect for any damaged parts.
• Install the legs in the sockets at the
underside of the water container and
fasten with the knobs.
• Level the sawing machine by adjusting
the legs in the sockets and make sure
its stable.
• Release the transportation lock.
®
405TS-406TS
Saw head
• By loosening the lever the saw head
Cooling system
• Place the plug in the drain of the water
• Fill up the container with water until
13
can be positioned at the desired
height .
ATTENTION!
Operating the water pump with-
out a sufficient supply of water
may result in pump damage.
container.
the water pump is submerged till the
pumpgrip.
GB