Cooling System; Unpacking And Set Up; Setting Up; Saw Head - Rodia 4050TS Bedienungsanleitung

RODIA
Cooling.system
1 From the plastic container underneath
the sawmachine the water will be
circulated . The electrical water pump
is switched on simultaneously with the
saw motor and supplies cooling water
to both sides of the saw blade .
 Water supply directly connected to
the waterline . Disconnect the water
pump hose . Connect the water hose
to the waterline . Water supply can be
regulated with the valve on the saw
machine . Mud
flaps prevent most
of the water mist
and make sure
most water flows
back in the water
container .
4050TS-4060TS
®

6. UNPACKING AND SET UP

Setting.up
• Unpack the sawing machine and
• Install the legs in the sockets at the
• Level the sawing
• Release the trans-
Saw.head
• By loosening the lever the saw head
Cooling.system
Fill up the container with water until the
water pump is submerged till the pump-
grip .
13
inspect for any damaged parts .
underside of the water container and
fasten with the knobs .
machine by adjust-
ing the legs in the
sockets and make
sure its stable .
portation lock .
can be positioned at the desired
height .
ATTENTION!
Operating the water pump
without a sufficient supply of
water may result in pump
damage.
GB