Various Sawing Processes; One-Step Sawing; Two-Step Sawing; Safety - Rodia 405TS Bedienungsanleitung

RODIA
7. VARIOUS SAWING
PROCESSES

One-step sawing

(Use only original saw blades as advised
by the manufacturer)
• Move saw head down until the saw is
appro. 10 mm below the saw table.
• Secure saw head with the knob.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop.
• Hold the material with two hands while
making sure your hands are free from
the sawing blade.
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial.

Two-step sawing

• Adjust the saw head in its top position.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop.
• Hold the material with two hands while
making sure your hands are free from
the sawing blade.
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial and move the sawing table back-
ward in its initial position.
• Rotate the material and cut it through
completely.
® 405TS-406TS

8. SAFETY

Besides the valid safety regulations atten-
tion to the following items should be made:
• Carefully follow the directions of set-
• Carefully check that the electrical con-
• Electrical cables should not come in
• Damaged saw blades should be
• Secure material to be cut by hand dur-
• Make sure your hands stay away as
• Wear protective goggles during saw-
• Wear hearing protection during saw-

9. MAINTENANCE

• The cooling water should be replaced
• It is recommended to clean the water
• When the machine is not used for a
• Regularly check the saw flanges for
15
ting up and working with the sawing
machine.
nections are correct.
contact with water or water spray.
replaced immediately.
ing sawing.
far as possible from the rotating saw
blade.
ing .
ing .
and/or replenished regularly.
container, pump, hoses and spray noz-
zle on a regular basis. For example,
place the pomp in a bucket of clean
water after the sawing job and run the
machine for a minute or so. This also
guarantees a longer lifetime of the
pump.
longer period, the pump should not
remain in the muddy cooling water.
Cleaning the pump as described
above and leaving it outside the water
container is better.
wearing out and replace if necessary.
GB