Connecting To Power Supply; Motor Protection; Installing The Saw Blade - Rodia 405TS Bedienungsanleitung

GB

Connecting to power supply

First, check whether:
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm 2

Motor protection

The motor is equipped with a thermal
safety switch for protection against an
overload. When the motor gets over-
heated, the switch falls back into its initial
position and can only be switched on
again after the motor is cooled down. The
switch also protects against power failure.
When the power returns, the motor will not
start on its own but must be switched on
by hand.
RODIA ®
.
405TS-406TS

Installing the saw blade

WARNING!
Make sure to disconnect the
machine from the power supply
before fitting or switching the
saw blade or when doing any
maintenance on the machine.
• Remove saw cover.
• Block the sawing spindle with the 8
mm Allen wrench.
• Unscrew the 30 mm hexagon nut
with the wrench and remove the saw
flange. (Attention: Left-handed screw
thread)
• Clean the saw flanges.
• Fit the saw blade on the centre ring of
the motor flange. (Check the direction
of rotation and make sure the blade is
well centred)
• Mount saw flange and tighten with
the hexagon nut. Place saw cover and
tighten with the 2 knobs .
14