Rollei Steady Butler Action Bedienungsanleitung Seite 9

4. Insert the Actioncam
Please remove the action camera underwater case and install the
camera before the gimbal is turned on .
1
2
GoPro Hero 6/5
1
The lens is next to the tilt motor .
Put the tilt motor to the RIGHT side, place the GoPro 6/5 closely
to the back clip as shown in the picture and tighten the knob to
secure its position . Double tighten by 2 long screws against violent
movement .
GoPro Hero 4/3, YI CAM,SJ CAM or other action camera of similar
2
size
The lens is opposite to the tilt motor .
Put the tilt motor to the LEFT side, place the GoPro 4/3 closely to
the back clip as picture and tighten the knob to secure its position .
Double tighten by 2 long screws against violent movement .
5. Operation
B
A A
B
1
3
2
4
Mode Button Working
Operation Modes
Single click Pan
Following
Double click Pan& Tilt
Following
Triple click All Locked Flashes three
Quartic click All
Following
Long Press for Calibration Solid on
6 Seconds
A Panning right/ left
B Tilting up/ down
1 Bluetooth Licht
• Solid on:
Bluetooth connected
• Quickly flashes twice:
Power on/off
2 Slider
• Up: Reset
• Down: Quick lock
3 Mode Button
4 ON/OFF (long press for about
3 seconds)
Indication Instruction
Light
Flashes once Default mode, tilt & roll
(quick flash) axis are both locked,
camera can move to
left or right smoothly .
Flashes Roll axis is locked,
twice camera can move to
the left/right, and tilt
up/down .
The camera stays in its
times current orientation /
position .
Flashes Tilt axis, roll axis
slowly and pan axis are all
following
Tilt or roll angle not
levelled with horizontal
surface, or pan angle
drift in lock mode .
9