Changing The Tool - Bosch GOP 10,8 V-LI Professional Originalbetriebsanleitung

The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A long
battery service life is achieved in this manner.
Removing the Battery
To remove the battery 2, press the unlocking
buttons 1 and pull the battery out of the ma-
chine to the rear. Do not exert any force.
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator 4 indicate the charge condition of
the battery 2. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
To indicate the charge condition, press and hold
button 3 of the switched off machine.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green

Changing the Tool

Before any work on the machine itself (e.g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the
On/Off switch.
Wear protective gloves when changing ap-
plication tools/accessories. Contact with
the application tool/accessoriy can lead to
injuries.
Bosch Power Tools
Selecting the Application Tool/Accessory
Capacity
≥2/3
≥1/3
<1/3
Reserve
* Optional accessory; for the complete accessories
please see Bosch accessory programme.
Accessory
HCS wood
segment saw
blade*
BIM segment
saw blade*
HCS plunge
cut saw
blades,
wood*
BIM plunge
cut saw
blades,
metal*
BIM plunge
cut saw
blade, wood
and metal*
HM-Riff seg-
ment saw
blade*
HM-Riff delta
plate*
Scraper,
rigid*
Scraper,
flexible*
Base plate
for sanding,
series Delta
93 mm*
2 609 140 535 | (26.5.08)
English | 21
Material
Wooden mate-
rials, plastic
Wooden mate-
rials, plastic,
non-ferrous
metals
Wooden mate-
rials, plastic,
gypsum and
other soft
materials
Metal (e.g.,
nails, screws,
small pro-
files), non-fer-
rous metals
Wood, metal,
non-ferrous
metals
Grouting
joints, soft wall
tiles, glass-fi-
bre reinforces
plastic and
other abrasive
materials
Carpets,
coverings
Silicone and
other elastic
materials
Depends on
sanding sheet