Troubleshooting; If Thin Lines Appear On Your Screen (Damper Wires); On-Screen Messages - Sony GDM-5402 Bedienungsanleitung

Troubleshooting

Before contacting technical support, refer to this section.
If thin lines appear on your screen
(damper wires)
The lines you are experiencing on your screen are normal for the
Trinitron monitor and are not a malfunction. These are shadows
from the damper wires used to stabilize the aperture grille and are
most noticeable when the screen's background is light (usually
white). The aperture grille is the essential element that makes a
Trinitron picture tube unique by allowing more light to reach the
screen, resulting in a brighter, more detailed picture.
Damper wires

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen.
If NO INPUT SIGNAL appears on the screen
I NFORMA T I ON
MON I TOR I S WORK I NG
I NPUT 1 :
NO I NPUT S I GNA L
ACT I VA T E US I NG PC
CHECK I NPUT SE L ECT R
CHECK S I GNA L CAB L E
WH I T E
RED
GREEN
B L UE
1 The selected connector
This message shows the currently selected connector
(INPUT 1 or INPUT 2).
2 The input signal condition
NO INPUT SINGAL
This indicates that no signal is input, or that no signal is input
from the selected connector.
3 The remedies
One or more of the following messages may appear on the
screen.
• If ACTIVATE USING PC appears on the screen, try
pressing any key on the computer, and confirm that your
computer's graphic board is completely seated in the
correct bus slot.
• If CHECK INPUT SELECTOR appears on the screen, try
changing the input signal (page 7).
• If CHECK SIGNAL CABLE appears on the screen, check
that the monitor is correctly connected to the computer
(page 6).
If OUT OF SCAN RANGE appears on the screen
1 The selected connector and the frequencies of the
2 The input signal condition
3 The remedies
For more information, see "Trouble symptoms and remedies" on
page 16.
O
I NFORMA T I ON
MON I TOR I S WORK I NG
I NPUT 1 : 1 3 0 . 0 k H z /
OUT OF SCAN RANGE
CHANGE S I GNA L T I M I NG
WH I T E
RED
GREEN
B L UE
current input signal
This message shows the currently selected connector
(INPUT 1 or INPUT 2). If the monitor recognizes the
frequencies of the current input signal, the horizontal and
vertical frequencies are also displayed.
OUT OF SCAN RANGE
This indicates that the input signal is not supported by the
monitor's specifications.
CHANGE SIGNAL TIMING appears on the screen. If you
are replacing an old monitor with this monitor, reconnect the
old monitor. Then adjust the computer's graphic board to that
the horizontal frequency is between 30 - 121 kHz, and the
vertical frequency is between 48 - 160 Hz.
7 5 H z
GB
15