Problems - Sagem PHOTO EASY 160 Bedienungsanleitung

Liasse AZUR_GB.book Page 36 Jeudi, 21. avril 2005 4:09 16
P
ROBLEMS
Remark : The printer is fitted with an automatic time-out to prevent overheating, this can be trip-
ped when performing large print jobs. The printer automatically restarts the current
print job as soon as the temperature drops back to normal.
P
ROBLEMS
No mains supply
The printer was unplugged
during a print job
No photograph is printed
on a sheet
The photograph is marked
with a continuous line or a
lot of spots
No PC printing
Photo chronology not
observed (the printed
photo is not the one
expected)
The timer icon is flashing
and nothing seems to be
happening
Solutions
• Check that the power supply block is correctly plugged
into the mains.
• Check that the power supply connector is correctly
plugged into the printer.
• Check that the mains socket is live (check fuses and/or
circuit breakers of your installation as necessary).
• Check that the printer is off and then reconnect the mains
lead.
• Switch on the printer and wait for the initialisation phase
to be completed.
• If a sheet of paper is jammed, carry out the procedure
(Refer to paragraph Paper jam, page -35).
• Restart printing.
• Are you using sheets that meet the technical
specifications (Refer to paragraph Technical data,
page -40)
• Have the sheets been inserted shiny face up?
• Clean the printhead (Refer to paragraph Cleaning the
print head, page -34).
• Check that the USB cable is correctly connected.
• Is the printer driver installed?
• Make sure that you are in 'Print' mode, not 'Memory
Card Reader' mode (see chapter 10)
• You must set the date and time on your camera
beforehand, and activate them before photographing.
• Wait: your printer is processing data, warming up or
cooling down.
- 36 -