General Introduction - Sundirect Smart1.0 Montageanleitung Und Bedienungsanleitung

1. General introduction

The Smart1.0 is specifically designed to work together with
Sundirect "Plus" range infrared panel heaters. Smart1.0 is a
wireless thermostat remote control. The receiver that pairs to
Smart1.0 has already been pre-assembled on the backside of the
panel.
One Smart1.0 can pair to more than one "Plus" heater, i.e.
multiple heaters within one room can be controlled by the
Smart1.0 thermostat.
The Smart1.0 will operate the "Plus" range infrared heaters by
turning them ON if the room temperature is lower than the
desired room temperature and will turn them OFF if the room
temperature is reached.
Please read these instructions carefully and keep safe for future
use. Failure to comply with these instructions will void your
warranty.
Smart1.0 is designed and produced to comply with the following standards:
Draft EN 301 489-1 V2.2.0:2017
Draft EN 301 489-3 V2.1.1:2017
EN 300 220-2 V3.1.1:2017
EN 62479:2010
EN 60950-1:2006/A2:2013