Operation Instructions; Pair To The Receiver - Sundirect Smart1.0 Montageanleitung Und Bedienungsanleitung

5. Operation instructions

5.1 Pair to the receiver

All "Plus" range heaters have a built-in
thermostat receiver-Receiver01 on
the backside of the panel. On the
right, see the drawing of the signal
lights and button of Receiver01. The
following is a detailed description of
the buttons and signal lights:
1.Pair status signal light (green light)
2.Heating status signal light (red light)
3."P" button
4. Power switch
Step1: Plug your heater to an electricity outlet, switch the Power
switch of Receiver01 on, double press the "P" button and the
"Pair signal light" will start to flash and is ready for pairing.
Step2: Power-off the Smart 1.0, long press the "SET" button. The
"PAIR" signal will show on the screen of the remote control. Wait
until the "Pair signal light" stops flashing and glows green to
finish the pairing.
Note: Once Receiver01 and Smart 1.0 are paired, the pair signal
light will always be on and the Receiver01 will be only
commanded by the Smart 1.0. One Receiver01 can only pair to
one Smart1.0, however, one Smart 1.0 can be paired to several
room.
Receiver01 if they are in the same