Fitting The Parts - Auping Ultimate Climate Type 783RC Gebrauchsanweisung

10.3 Fitting the parts

You need only remove the mattress
cover if you want to wash it or if you
suspect that plug D (see fig. 37) is
not connected properly.
A. Positioning the main mattress
body
fig. 34
Put the bed in the flat position.
Place the mattress body (A) on the
mesh base. Check the position of
the couplings!
fig. 35
Press down with two hands on the
mattress where the mattress
couplings are positioned. The
mattress base will connect with an
audible click.
GB 20
1695 bw.pdf - pag.46
A
2x
B. Installing the topper
Place the topper (B) on the mattress
body with the heating element ("this
side up") in such a position that the
two small cables come together in
the same corner. Place the topper
precisely in the centre without any
folds or creases.
Press the plugs (D) together until you
hear a click. Then fold the cable and
the plug flat against the mattress.
Place the mattress cover (C) over
the topper and close the zipper.
LET OP !!! Lage resolutie!
B C
D
fig. 36
fig. 37
February 16, 2006