General - Auping Ultimate Climate Type 783RC Gebrauchsanweisung

5.2 General

fig. 15
G
fig. 16
The mattress heating is adjusted
with the remote control (fig. 15). You
can choose between manual or
automatic control of the heating and
drying functions. These functions can
be programmed and the procedure
is explained in this chapter.
You can set the temperature of the
foot zone (G) and the body zone (H)
(fig. 16) independently of each other.
The pilot lights on the remote control
indicate the set temperature level. It
takes about two hours to heat the
mattress to the preset temperature
level.
Please keep this in mind and activate
the heating function in time before
going to bed.
The maximum heating period is
limited to 12 hours. After 12 hours
the heating system will be switched
off automatically.
GB 8
1695 bw.pdf - pag.34
P start end now
P
H
People lose about a quarter of a litre
of moisture at night while sleeping.
The mattress largely absorbs this
moisture. Activate the drying function
after getting up in the morning to
keep the mattress in top condition.
5.2.1 Manual body zone heating
control
A
P
Setting the heating level
Set the heating level with the – and
+ buttons (A and B).
The pilot lights at the top indicate
the set heating level.
The maximum heating level for use
during the night while sleeping or
lying down is level 5.
(Maximum of 5 indicator lights on the
remote control being lit up.)
LET OP !!! Lage resolutie!
start end now
P
H
B
fig. 17
fig. 18
February 16, 2006