Pre-Programmed Settings - Auping Ultimate Climate Type 783RC Gebrauchsanweisung

5.3.2 Pre-programmed settings

The Ultimate Climate Advanced is
pre-programmed on delivery. When
you activate the program, the
mattress heats and dries according
to the settings in the table below.
Start heating
Body zone
Foot zone
Stop heating
Start drying
Current time
5.3.3 Setting/adjusting personal
preferences
Although the Ultimate Climate
Advanced is pre-programmed on
delivery (see Chapter 5.3.2: Pre-
programmed settings) you can
always adjust these settings to your
personal preferences, for example if
you find that the heating level of the
body zone is too low.
In this chapter you can read which
settings you can program yourself.
Please note: If you do not operate
any key for more than ten seconds,
the settings entered up to that time
will be saved automatically. The pilot
lights will go out. In that case press
the key
1695 bw.pdf - pag.37
21.00
level 4
level 5
09.00
11.00
00.00
to continue programming.
P
A. Before adjusting your
preferences
Make sure that the program is
activated (see Chapter 5.3.1:
Activating/deactivating the program)
before you start programming
(adjusting your preferences).
B. Adjust heating starting time
A
P
C
Press the button (F)
The pilot light below the symbol
will be illuminated.
The text START HEATING will appear
in the display with the time at which
heating commences.
Adjust the starting time with the
– and + buttons (A, B, C or D).
Please note: Set the time to at
least 2 hours before you go to bed.
LET OP !!! Lage resolutie!
START HEATING
+
– 20:00
start end now
P
F
P .
B
fig. 26
D
start
GB 11
February 16, 2006