Operating The Ultimate Climate Advanced; Preparing For Use; Setting The Current Time; Setting The Language - Auping Ultimate Climate Type 783RC Gebrauchsanweisung

5. Operating the Ultimate Climate Advanced

5.1 Preparing for use

Before using the Ultimate Climate
Advanced you must check whether
the display shows the correct time
and is set to the correct language.
Make sure that the program is
activated before adjusting the time
and/or language (see Chapter 5.3.1:
Activating/ deactivating the
program).

5.1.1 Setting the current time

You have to manually reset the time
to correspond with winter or daylight
saving time. A time reset is also
required when a power cut has lasted
longer than 30 minutes.
A
fig. 12
C
Press the Programming button (F)
repeatedly until the pilot light beneath
the symbol
The text CURRENT TIME will appear
in the display, for example 13:00 .
Check if the time shown is correct.
If necessary the time can be adjusted
with the – and + buttons (A, B, C
or D).
1695 bw.pdf - pag.33
CURRENT TIME
+
– 13:00
P start end now
P
F
is illuminated.
now
P
Press the Programming button
(F) . The settings will be saved.
P
The text SETTINGS ACTIVATED will
appear in the display.
The green pilot light below the P will
remain on.

5.1.2 Setting the language

B
A
P
D
C
P
Press the – button for the foot
zone (C), the button (E)
+ button for the body zone (B)
simultaneously for three seconds.
Select the language of your choice
with the – and + buttons (A, B, C
or D).
Confirm your choice by pressing the
button (F)
LET OP !!! Lage resolutie!
SETTINGS
ACTIVATED
start end now
P
F
E
LANGUAGE UK
CONFIRM WITH P
start end now
P
F
and the
.
P
fig. 13
B
fig. 14
D
GB 7
February 16, 2006