Hilti TE 6-A22 Originalbetriebsanleitung Seite 27

5.6 Fitting / removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
▶ Fit / remove the chuck.
5.7 Inserting the tool
1. Lightly grease the connection end of the accessory tool.
◁ Use only genuine Hilti grease. Using the wrong grease can result in damage to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
◁ The product is ready for use.
5.8 Removing the accessory tool
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.9 Overhead work 9
▶ Fit the DCD dust control ring for overhead work.
5.10 Chisel positioning
▶ Set the function selector switch to the
6 Types of work
Warning! Risk of damage!
▶ Operation of the direction of rotation and/or function selector switch while the tool is running may
result in damage to the tool.
▶ Do not operate this switch while the tool is running.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Function selector switch
▶ Set the function selector switch to the desired working position.
◁ Do not operate the function selector switch while the motor is running. Risk of damage!
6.2 Forward/reverse
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Drilling without hammer action
▶ Set the function selector switch to the
6.4 Drilling with hammer action
▶ Set the function selector switch to the
6.5 Chiseling
▶ Set the function selector switch to the
◁ For optimum motor cooling, select the forward direction, i.e. clockwise (direction of rotation for
drilling).
Printed: 29.08.2017 | Doc-Nr: PUB / 5329708 / 000 / 01
6
7
8
10
position.
10
11
position.
position.
position.
English 19