Smartsafe™ Failsafe; Hold Last Command - Spektrum AR7010 Bedienungsanleitung

4. Follow the procedures of your specific transmitter to enter Bind Mode, the sys-
tem will connect within a few seconds. Once connected, the LED on the receiver
will go solid indicating the system is connected.
5. Remove the bind plug from the BIND/DATA port on the receiver before you
power off the transmitter and store it in a convenient place.
6. After you've set up your model, it' s important to rebind the system so the true low
throttle and neutral control surface positions are set.
NOTICE: Remove the bind plug to prevent the system from entering bind mode the
next time the power is turned on.
SmartSafe™ Failsafe
SmartSafe Failsafe is always active in both the hold last command failsafe and in
the preset failsafe. SmartSafe technology is a safety feature on the throttle channel
that offers the following benefits:
• Prevents electric motors from operating when the receiver is turned on
(no signal present)
• Prevents the speed controller from arming until the throttle is moved to low
throttle position after connection is made
• Shuts off the electric motor and reduces gas/glow engines to idle if the signal
is lost
• If the throttle is at any position other than low, the ESC won't arm
• If connection is lost in flight, SmartSafe technology sets the throttle to the
position it was in during the binding process.
How To Program
The SmartSafe program is automatically set when the hold last command failsafe or
Preset failsafe is programmed or the system is bound. Always to have the throttle
stick in the low position to store low throttle during binding.
To Test
Confirm the failsafe setting is correct by turning off the transmitter. The throttle
should go to the preset low throttle position.
CAUTION: Make sure the aircraft is restrained on the ground. If failsafe is
not set, your aircraft might advance to mid or full throttle.

Hold Last Command

If you lose connection, all channels except for throttle channel hold last given
command and the aircraft continues on its path. So, if you were turning when
connection was lost, your aircraft would continue turning.
How to Program
1. Leave the bind plug in the bind port through the entire binding process.
2. Remove bind plug only after receiver connects to transmitter.
To Test
Confirm the failsafe settings are correct by turning off the transmitter. All channels
except for the throttle should hold the last command.
CAUTION: Make sure the aircraft is restrained on the ground. If failsafe is
not set, your aircraft might advance to mid or full throttle.
9
EN