Spektrum AR7010 Bedienungsanleitung Seite 12

EN
Using the Flight Log
After a flight and before turning off the receiver or transmitter, plug the Flight Log into
the BIND/DATA port on the AR7010. The screen will automatically display voltage
e.g. 6v2= 6.2 volts.
When the voltage reaches 4.8 volts or less, the screen will flash, indicating low voltage.
Press the button to display the following information:
A - Antenna fades on the internal antenna B - Antenna fades on the external
L - Not used
F - Frame loss
Antenna fades—represents the loss of a bit of information on that specific antenna.
Typically it' s normal to have as many as 50 to 100 antenna fades during a flight. If any
single antenna experiences over 500 fades in a single flight, the antenna should be
repositioned in the aircraft to optimize the RF link.
Frame loss—represents simultaneous antenna fades on all attached receivers. If
the RF link is performing optimally, frame losses per flight should be less than 20. A
hold occurs when 45 consecutive frame losses occur. This takes about one second. If a
hold occurs during a flight, it' s important to evaluate the system, moving the antennas
to different locations and/or checking to be sure the transmitter and receivers are all
working correctly.
A servo extension can be used to allow the Flight Log to be plugged in more conveni-
ently. On some models, the Flight Log can be plugged in, attached and left on the model
using double-sided tape. Mounting the Flight Log conveniently to the side frame is
common with helicopters.
ModelMatch™
Some Spektrum and JR transmitters offer a patent pending feature called ModelMatch.
ModelMatch technology prevents the possibility of operating a model using the wrong
model memory, potentially preventing a crash. With ModelMatch, each model memory
has its own unique code (GUID) and during the binding process the code is program-
med into the receiver. Later, when the system is turned on, the receiver will only connect
to the transmitter if the corresponding model memory is programmed on screen
If at any time you turn on the system and it fails to connect, check to be sure
the correct model memory is selected in the transmitter. Please note that the DX5e
and Aircraft Modules do not have ModelMatch technology.
antenna
R - Not used
H - Holds
12