Preset Failsafe - Spektrum AR8010T Bedienungsanleitung

EN
Failsafe
Failsafe position is set during binding. In the unlikely event that the radio link
is lost during use, the receiver will drive all channels to its pre-programmed
failsafe position.
SmartSafe + Hold Last
(AR8010T/AR9030T)
If loss of signal occurs, SmartSafe™
technology moves the throttle channel
to its preset failsafe position (low throttle)
that was set during binding. All other
channels hold their last position. When
the receiver detects signal from the
transmitter, normal aircraft operation
resumes.
Tip: Use either the built in BIND button OR a bind blug in the BIND/BATT port.
SmartSafe +
Hold Last
1
Lower Throttle on transmitter
2
Push and Hold Bind Button
3 Power on Reciever
Release Button once RX goes into Bind
4
Mode (flashing LED)
Place transmitter in Bind Mode and
5
finish Binding.
A* Install bind plug (optional)
B* Leave in through entire bind proccess**

Preset Failsafe

Move all sticks and switches on the
1
transmitter to desired Failsafe position.
2 Push and Hold Bind Button
3
Power on Reciever
Release Button after RX goes into Bind
4
Mode (flashing LED)
Push and Hold the Bind Button again
5
before the transmitter enters Bind Mode.
A* Install bind plug (optional)
B* Remove plug once RX goes into Bind Mode Leave in through entire bind proccess**
*Setting Failsafe can be done with the Bind Plug if desired.
**Remove Bind Plug when finished setting up Failsafe.
6
Preset Failsafe
(AR9320T)
Preset failsafe is ideal for sailplanes,
allowing the aircraft to automatically
dethermalize if the signal is lost. With
preset failsafe, all channels go to their
preset failsafe positions if the signal
is lost, preventing a flyaway. When
the receiver detects signal from the
transmitter, normal aircraft operation
resumes.
AR8010T/
AR9030T
Move all sticks and switches on the
transmitter to desired Failsafe position.
Push and Hold Bind Button
Power on Reciever
Release Button after RX goes into Bind
Mode (flashing LED)
Place transmitter in Bind Mode and
finish Binding.
Install bind plug (optional)
AR9320T
NA
NA
NA
NA
NA
NA