English - Philips HR 2702 Gebrauchsanweisung

English

Important
• Read the instructions in conjunction
with the illustrations before using the
appliance.
• Care must be taken when handling the
circular blade as it is very sharp.
• Do not allow children to operate the
appliance.
• Remove the mains plug from the wall
socket after use.
• If the mains cord of this appliance is
damaged, it must only be replaced by
Philips or their service representative,
as special tools and/or parts are
required.
• Prior to initial use, clean all the parts
which come into contact with food.
• Never immerse the motor unit in water
or any other liquid. Do not rinse either.
• Keep these instructions for future
reference.
General description
A
Cord storage
B
On / off switch safety guard (button)
C
On / Off switch (button)
D
Circular blade (stainless steel)
(4822 690 40311)*
E
Blade lock
F
Blade cover (4822 466 10792)*
G
Remainders holder (4822 256 10158)*
H
Carriage (4822 466 10794)*
ISupport table (4822 466 10795)*
J
Stop plate (4822 466 10793)*
KCutting width control (max. 24 mm)
L
Suction pad feet (4822 462 10641)*
M
Tray (4822 450 10075)*
N
Carriage lock (slide)
Spare parts are available for replacement. Apply
to your dealer referring to the service number
(...)*.
(fig. 1)
Making ready for use
- Unwind the mains cord to the desired length
and secure it (fig. 2).
- Place the appliance on a smooth stable
surface. Press down so that the suction pad
feet adhere tightly for maximum stability.
- Attach the carriage to the support table
(fig. 3-4).
- Attach the remainders holder to the carriage
(fig. 5).
Switching on and off
The switch guard locks the On / Off button, to
prevent unintended switching on.
- Press and hold the switch guard. Push down
the On / Off button (fig. 6).
- Release the switch guard (fig. 7).
As long as the On / Off button remains in down
position, the appliance is switched on.
- To switch off, just release the On / Off button
(fig. 8).
The switch guard springs back into its original
position.
Cutting width setting
- Set the desired cutting width (max. 24 mm) by
rotating the control knob. Refer to the the scale
(fig. 9-10).
• For safety, always rotate the control knob
anti-clockwise until it stops. (Minimum
cutting width.)
Hinged carriage and remainders lock
• For safety: Always place the remainders
holder on the carriage for cutting rest
pieces.
Use
The universal cutter slices bread, meat,
sausage,cheese, vegetables and fruit easily
(fig. 11-12).
Press the food to be sliced lightly against the stop
plate and slide slowly against the running blade.
Please note: The appliance is intended for
domestic use.
Do not operate the appliance longer than 10
minutes without a pause.
4