Philips HR 2702 Gebrauchsanweisung Seite 5

CIeaning
• Switch off and remove the mains plug from the
wall socket before cleaning. Wait for the
circular blade to come to a complete standstill.
• Never immerse the basic appliance (i.e. the
part containing the motor) into water or any
other fluid. Do not rinse either.
• Clean the appliance with a damp cloth
immediately after use, including the circular
blade. Do not use any scouring cleaning
materials. Do not clean in a dishwasher.
Attention: the blade is very sharp.
Circular blade
To disassemble the circular blade:
- Remove the blade cover (fig. 13).
- Rotate the blade lock a quarter turn clockwise
(fig. 14).
When the lock is in a vertical position the
circular blade can be removed (fig. 15).
To reassemble the circular blade:
- Rotate the blade lock a quarter turn anti-
clockwise.
When the lock is in a horizontal position the
circular blade is fixed.
Ensure that the blade is safely assembled
before switching on.
- Replace the blade cover (fig. 16-17).
Stop plate
To disassemble the stop plate:
- Turn the control knob anti-clockwise until it
stops (fig. 18).
- Then take off the stop plate (fig. 19).
To reassemble the stop plate:
- Insert the stop plate, press on lightly and turn
the control knob clockwise (fig. 20).
Carriage lock (slide)
Before storing the appliance you can fixate the
carriage in the foremost position (fig. 21).
For U.K. only:
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp.
plug.
Should you need to replace the plug, connect the
wires as follows:
Green/yellow wire to the Earth terminal (E) of the
new plug.
Brown wire to the Live (L) terminal of the new
plug.
Blue wire to the Neutral (N) terminal of the new
plug.
Always fit the same value of fuse as that originally
supplied with your appliance.
Only use BS 1362 approved fuses.
As a guide only: Appliances under 700 W can
have a 3 Amp. fuse (red) and all others should
have a 13 Amp. fuse (brown).
When disposing of an old plug (particularly the
moulded type which has been cut from the mains
cord) always remove the fuse as the plug could
be dangerous if ever inserted in a live socket.
5