Bosch GHO 14,4 V Bedienungsanleitung Seite 15

External Dust Extraction
The chip ejector 3 fits on both sides for direct
connection of the Bosch vacuum hose Ø =
35 mm 21 (accessory). When using other vac-
uum hose systems a suitable extraction adapter
may be required.
The vacuum cleaner must be suitable for the ma-
terial to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
Integrated Dust Extraction
A dust/wood chip bag 22 (accessory) can be
used for smaller jobs.
Empty the dust/wood chip bag regularly. Re-
move the dust/wood chip bag, open the zipper
and empty the dust/wood chip bag.
Choice of Chip Ejector Side
(Right/Left)
The chip ejector 3 can be switched to the right or
left with the change lever 6.
Always press the change lever until it engages in
the end position.
The selected ejector direction is marked with an
arrow.
Operating Instructions
Planing
Set the required planing depth and place the front
part of the planer shoe 13 against the workpiece.
Caution! Danger of kickback!
Apply the machine to the workpiece
only when switched on.
Switch the machine on and guide the machine
with an even feed over the surface to be planed.
To achieve high-grade surfaces, work only with
low feed and apply pressure on the centre of the
planer shoe.
15 • 2 609 932 079 • 03.03
When machining hard materials (e. g. hardwood)
as well as when utilising the maximum planer
width, set only low planing depths and reduce
planer feed, as required. Repeat the planing sev-
eral times.
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
Beveling Edges (see figure
The V-grooves 14 in the front planer shoe 13 al-
low quick and easy beveling of workpiece edges.
Depending on required bevel width, use the cor-
responding V-groove.
For this, place the planer with the V-groove 14
onto the edge of the workpiece and guide along
the edge.
Using the Parallel/Angle Guide
(Accessory – see figure
Mount parallel guide 15 or angle guide 19 to the
machine using fastening bolt 16 and rebating
depth stop 2 using fastening bolt 1.
Loosen locking nut 17 and adjust the required re-
bating width with the scale 18. Retighten locking
nut 17 again.
Adjust the required rebating depth accordingly
with the rebating depth stop 2.
Carry out the planing procedure several times,
until the required rebating depth is reached. Pay
attention that the planer is guided with sideward
supporting pressure.
Beveling (only angle guide 19)
When beveling rebates and surfaces, adjust the
required slope angle with the angle adjust-
ment 20.
English - 4
)
B
)
C