Fire Safety - Kirami CUBE Gebrauchsanweisungen

29.06.2014

FIRE SAFETY

If the heater is located near buildings, for example on the
side of a terrace, the distance of the chimney from any
combustible materials must be adequate. Remember to
check the distance both laterally and vertically so that there
isn't any risk of fire. Safe minimum distance, from the
chimney's upper end, laterally is three (3) meters. Shorter
distance laterally is adequate in other parts of the chimney. If
the chimney is closer to any combustible materials you must
use special insulated chimney, which has to be purchased
separately.
When positioned close to the roof or when taken through it, the top end of the insulated chimney
must be at least one (1) meter above the surface of the roof. Ask your local fire officer for more
information.
Notice also the fire safety in front of the furnace. There shouldn't be any combustible materials in
front of the furnace. There should be an area, which is demonstrated in the picture that should be
made of incombustible material such as concrete, sand or metal.
Grates
For the CUBE heater, two cast iron grates and one L-shaped iron plate will
be delivered. Those are to be positioned on the tracks in the heater. The
order of the grates is shown on the right side. L-shaped iron plate is to be
installed bended edge upwards. It will deflect the air and also prevent the
firewood to drop out from the heater.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with this heater. The reduced end of the
chimney fits inside the heater. The chimney parts can be purchased separately in three different
lengths: 20 cm, 50 cm and 100 cm. There are also available adjustable chimney corners and 100 cm
long protective sleeves for the lower part of the chimney.
We recommend a chimney kit for the heater. This package includes 200 cm chimney + 100cm
protective sleeve and a standard hat. There are also spark protective
hats available for the chimney.
If you have purchased a chimney kit with the heater. It is supplied in a
separate box and has four parts (see picture right) and it has to be
assembled.
Remove the protective film from the thermal protection and place the
assembled chimney to the chimney outlet of the stove.
Be careful, the edges of the chimney are very sharp. Use
protective gloves!
User manual: Kirami CUBE Hot tub heater Page 5
21/56