Kirami CUBE Gebrauchsanweisungen Seite 20

29.06.2014
Installation for Original Woody tubs
Kirami wooden tubs have Ø75mm connection pipe pieces and
preinstalled holes with bolts and nuts to fix the connection plates
delivered with the tub.
1) Install the delivered plates and leave them loose, it makes the
insertion of the heater easier.
2) The heater is pushed into its place so that the tub pipes go
inside the hoses on the heater. And the heater remains in
horizontal position.
3) Tighten the hose clamps form both ends. And the tub plates.
4) Use the supplier self-drilling screws to fix the heater to the
tub's plates. The screws are meant to drill through the wooden
panel, the tub plates and the heater plates. There should be
three screws on each side of the heater. Four top ones make
the actual fixing and the two lower ones fix the panel so that it
Installation for Original Easy and Comfort Cozy
tubs
The plastic Easy and Cozy hot tubs do not have connection
plates. So the heater is connected just with the hoses and
clamps just like Woody installation points 2) and 3). If you have
purchased a Macu drink holder or version of the hot tub with
covering side plates those can be attached with included
screws to the heater plates. With plastic hot tubs the heater
must have some supports underneath so that it will not hang
from the hoses.
Installation further away from the tub
The standard heater should not be installed further away from
the tub. If you are planning installation further away from the tub then you should purchase a
special version with extra emptying valve + air release valve on top. And also buy a separately sold
extension tube set with intermediate pipes, extra clamps and rubber hoses. When installing further
away the heater must be a bit lower than the tub so that the natural circulation of heated water
works. Remember to install the emptying valve and air release valve on the heater in this case. Also
build a support for the heater when it is not fixed on the tub. And remember to empty the heater
from its own valve after use.
User manual: Kirami CUBE Hot tub heater
stays in nice vertical position. If a drink
holder / panels is not installed the only
two screws are used on both sides.
The heater will be hanging on the wall
of the tub by the hoses ad plates
20/56
Page 4