Information Regarding The Handling Of Batteries; The Appliance Components; Setting Up The Appliance - Silvercrest SKRP 1000 A1 Bedienungsanleitung

present) must be removed and then re-
inserted.
Information regarding the
handling of batteries
The appliance uses a battery for memo-
ry conservation. For the handling of bat-
teries please observe the following:
Risk of explosion!
• Never subject batteries to excessive heat,
such as direct sunlight, fire, etc. Do not
recharge the batteries.
• Never open batteries, never solder or
weld batteries. The risk of explosions
and injuries exists!
• Non-observance of the correct polarities
when inserting the battery may cause
an explosion. The battery may only be
replaced by one of the same or an
equivalent type.
• Regularly check the condition of the bat-
teries. Leaking batteries can cause dam-
age to the appliance.
• If you do not intend to use the appliance
for an extended period, remove the bat-
teries.
• Should the batteries leak, put on a pair
of protective gloves and clean the battery
compartment and terminals with a dry
cloth.
Important !
No liability/warranty will be consid-
ered for damage to the Kitchen Radio
caused by the effects of moisture, water
penetration or overheating!

The appliance components

q Mounting plate/Baseplate
w Power cable
e Wire aerial
r Display
t–i M1–M4 - Memory buttons M1–M4
o MEM/AMS - to save and automatically
search for and save radio
stations
a MEM.SCAN - automatic recall of saved
s TIMER
d Illuminated clamp strip
f AL2/VOL — - controls the alarm function 2
g AL1/VOL + - controls the alarm function 1
h USER/BAND - User switching,
j LIGHT/
DIMMER
k MODE/
LOCK
l DOWN

1( UP

2) Battery compartment
2! ON/AOT/ - Switch the radio on/off
OFF

Setting up the appliance

First take all appliance components from the
packaging and remove all packing foil and
tape.
Inserting the battery
By inserting the batteries you will avoid the
loss of programmed times and alarm timings
in the event of a possible power outage.
The batteries ensures that the internal clock
continues to run even during a power failure.
When power is restored the correct time ap-
pears automatically in the display r.
Note:
The appliance can also be operated
without a battery.
1. Open the cover of the battery compart-
ment 2) on the underside of the appliance
by turning the cover with a coin to the left
and the limit stop and then lifting it.
2. Now place the battery of the type
CR2032 (supplied) in the battery com-
partment 2). The side with the marking +
should face upwards.
- 40 -
radio stations
- controls the timer
programming
- Volume reduction
- Volume increase
Radio waveband switching
- controls the display and
clamp strip illumination
- recalls the settings,
Button lock
- Selection button down
- Selection button up
controls the switch off timer