Fitting And Removing Harness; Testing The Battery; Checking Leds And Beeps; Connecting And Disconnecting Battery - Stihl AR 1000 Gebrauchsanleitung

English
8.2

Fitting and Removing Harness

8.2.1 Putting On and Adjusting the Carrying System
► Place battery on your back.
► Close fastening (2) of hip belt.
► Close fastening (1) of chest strap.
► Tighten up the straps until the hip belt sits snugly on your
hips and the back padding sits snugly on your back.
► Thread end of hip belt through the loop (3).
8.2.2 Removing the Carrying System
► Loosen the straps.
► Open the buckles on the chest strap and waist belt.
► Take the battery off your back.
30
1
3

9 Testing the Battery

9.1

Checking LEDs and beeps

► Press button on battery.
The LEDs glow green and a short beep sounds. The state
of charge is indicated.
► If the right-hand LED flashes green and there are four long
beeps: Charge the battery.
► If the LEDs do not glow or flash or there are no beeps: Do
not use the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.

10 Connecting and Disconnecting Battery

10.1 Connecting battery to a STIHL cordless product

with a socket

► Hold connecting cable plug (1) so that the arrow on its side
lines up with the arrow point on the socket (2).
► Insert the connecting cable plug (1) in the socket (2).
9 Testing the Battery
2
1
0458-794-9921-C