Environmental Information - GUTMANN Rayo Montageanleitung

en
4. Push the tube from below into the
motor module until the metal clip on
the inside of the cover is positioned to
contact the motor module (4 x).
5. Screw the metal clips with the tube
from above to the cover of the motor
module (4 x).
6. Now insert the threaded rods into the
tube. The hood can now be installed
with the threaded rods.
18
Note:
- Observe the separate operating and
installation instructions for recirculating
air hoods and the use of carbon filters.
- For summer-winter or VSA switch:
observe the separate instructions!
Disposal Packaging
The appliance packaging is recyclable.
Cardboard and polyethylene film (PE)
are used as packaging material. These
materials must be disposed of in an
environmentally friendly manner and in
accordance with the currently valid on-
site regulations.

Environmental Information

This appliance is labelled in accordance
with European Directive 2002/96/EG
conceming used electrical and elec-
tronic appliances (waste electrical and
eleclronic equipment - WEEE). The
guideline determines the framework for
the return and recycling of used appli-
ances as applicable throughout the EU.
Please ask your dealer about current
means of disposal.