HQ Power VDPC146 Bedienungsanleitung Seite 4

Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
•
device against damage by leaving it switched off until it has reached room temperature.
• This device is designed for professional use on stage, in discos, theatres, etc. The device should only be
used indoors with the appropriate current and power supply (see Technical Specifications below).
Use the original packaging if the device is to be transported.
•
Do not remove the serial number sticker from the device as doing so will void the warranty.
•
Keep this manual for future reference.
•
4. Features
24 memory slots: with storage capacity for running light programs of up to 99 steps each
•
functions: up chase/down chase, single or mix chase dark, full on, fade, tap sync and hold
•
manual or music controlled
•
midi connection facility (midi in): to run the unit synchronously with your midi unit
•
speed setting for the running lights with a large control range
•
• dimmer control per channel
• clear LED indication for: rec step, dimmer, speed and fade duration
max. 48 patterns with 4600 scenes can be programmed (12 programmes under 4 pages)
•
possibility to connect a foot switch (6.35 mm stereo jack plug)
•
for panel mounting or stand-alone use
•
5. Overview
Refer to the illustrations on page 2 of this manual.
Front panel (image A)
1 LED indicators for PRESET A dimming controls
2 Channel sliders (1 – 12)
3 Flash Keys (1 – 12)
4 LED indicators for preset B dimming controls
5 LED indicators for scene or chase selection
6 Channel sliders (13 – 24)
7 Flash keys (13 – 24)
8 MASTER A fader
9 BLIND
9 Master B fader
11 HOME
12 Fade Time Slider
13 TAP SYNC
14 SPEED slider
15 FULL ON
16 AUDIO LEVEL slider
17 BLACK OUT
V. 02 – 21/10/2013
VDPC146
The LED lights when the slide control is moved
upwards.
Adjust the output of each channel between 0 – 100%
or 0 - 255.
Press a flash key to make a channel jump to 100%
output.
The LED lights when the slide control is moved
upwards.
Adjust the output of each channel between 0 – 100%
or 0 - 255.
Press a flash key to make a channel jump to 100%
output.
Press this button simultaneously with a channel flash
key to deactivate that channel in CHASE/SCENES
mode.
Press this button simultaneously with a channel flash
key to reactivate that channel in CHASE/SCENES
mode.
Adjust the fade time with this slider.
Press this button twice to the rhythm of the music to
define the chase speed during the AUTO CHASE
mode.
To adjust the chaser speed manually.
Press this button to make all channels jump to 100%
output.
Adjusts the music sensitivity of the audio input.
Press this button to reduce the output of all channels
to zero.
4 ©Velleman nv