Hands-Free Function - THOMSON WHP-6007B Bedienungsanleitung

5.3. Audio playback
Note
• Note that the functions described under 5.3. and
5.4. are only possible with an active Bluetooth
connection.
• Your terminal device must also support the
individual functions (in particular, it must support
Bluetooth profiles).
• For more information, please refer to the operating
instructions of your terminal device.
• Functions can still be controlled directly via the
terminal device.
• Set the volume on your terminal device to a low level.
• Start audio playback on the connected terminal device.
The function LED emits flashes of blue light during
playback.
• Press the multifunction button (4) to start or pause
audio playback.
• Press the + button (1) to skip to the next track.
• Press the – button (2) to skip to the previous track.
• Press and hold the + button (1) to increase the volume.
• Press and hold the – button (2) to reduce the volume.

5.4 Hands-free function

You can use the headset as a hands-free set for your
mobile phone if your terminal device supports it.
Accept:
Press the multifunction button (4) once to answer an
incoming call.
Hang up:
To end the call, press the multifunction button (4) once
more.
Reject:
Press and hold the multifunction button (4) for about 2
seconds to reject an incoming call.
Redial:
While the headset is connected to your mobile phone
and in standby mode, press the multifunction button
twice to redial the last number dialled.
4
Forwarding a call from the headset to the con-
nected mobile phone:
Press and hold the – button (2) for about 2 seconds to
forward a call from the headset to the mobile phone. To
forward the call back to the headset, once more press
and hold the – button (2) for about 2 seconds.
5.5 Disconnecting the headset
Turn off the headset by pressing and holding the multi-
function button (4) for about 2 seconds.
5.6 Battery level
• An acoustic signal sounds and the display flashes in
red when the battery is low.
• Charge the headset as described in 4. Getting Started
6. Connecting to a hi-fi system or TV
An audio cable (3.5 mm jack) can be used to connect the
headset to audio devices that are not Bluetooth-enabled.
• Connect the audio cable to the AUX socket (7) and
to the line-out connection of your audio device (for
example, hi-fi or TV).
• If the headset is in ON mode, it automatically switches
off as soon as the audio cable is plugged in.
• Here, the volume is controlled solely using the audio
device (for example, hi-fi, TV).
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents. Make
sure that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com