Maintenance Chart - AGT 2835 PR Bedienungsanleitung

MAINTENANCE CHART

Please note that the following maintenance intervals apply for
normal operating conditions only. If your daily work requires
longer than normal or harsh cutting conditions are present,
then the suggested intervals should be shortened accordingly.
Complete Machine
Controls (Ignition
Choke Lever, Throttle
Trigger, Trigger interlock)
Fuel Tank
Fuel Filter
Cutting Attachments
Bevel Gear
Clutch Drum (2)
Cutting Attachments Guard
Spark Arrestor Screen (in
Muffler)
All Accessible Screws and
Nuts (Not Adjusting Screws)
Air Filter
Cylinder Fins
Starter System Vents
Starter Rope
Carburetor
Spark Plug
Vibration Mounts
Cutting Attachments
and screws
Cutting Attachments
and screws
Engine Oil (1)
Valve clearance (2)
Combustion chamber
Fuel tubes
Oil tubes
(1) After first month change Engine Oil.
(2) These items should be serviced by your servicing dealer, unless you have the proper tools and are
mechanically proficient.
Inspect (Leaks, Cracks, and
Wear)
Clean after finishing daily
work
Switch,
Check Operation
Inspect (Leaks, Cracks, and
Wear)
Clean
Inspect
Clean, Replace Filter Element
(2)
Inspect (Damage, Sharpness,
and Wear)
Check Tension
Sharpen
Inspect (Damage, Wear and
Grease Level)
Inspect (Damage, and Wear)
Replace
Inspect (Damage, and Wear)
Replace
Inspect (Damage, and Wear)
Clean or Replace
Inspect
Retighten
Clean
Replace
Clean
Clean after finishing daily
work
Inspect (Damage, and Wear)
Replace
Check
Attachments must not rotate
at (idle)
Check Electrode Gap
Replace
Inspect (Damage, and Wear)
Replace by Dealer
Check that the locking nut of
nuts
the cutting
tighteen correctly
nuts Check that nuts and screws
are tight
Check level
Change
Check - adjust
Clean
Check
Check
X
X
X
X
X
X
X
X
X
X
Idle (Cutting
X
equipment is X
X
X
Every 300 hrs. (2)
Every 2 years (Replace if necessary) (2)
Every 2 years (Replace if necessary) (2)
X
X
X X
X X
X
X
X X
X
X X
X
X
X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X
X
41