AGT 2835 PR Bedienungsanleitung Seite 13

Filling the Tank
WARNING: Follow safety instructions for fuel handling. Always shut off the engine before
refuelling.
Never add fuel to a machine with a running or hot engine.
Move at least 3 m from the refuelling site before starting the engine. DO NOT SMOKE!
1. Clean the surface around the fuel cap to prevent contamination.
2. Slowly loosen the fuel cap.
3. Carefully pour the fuel into the tank. Avoid spillage.
4. Prior to replacing the fuel cap, clean and inspect the gasket.
5. Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage.
WARNING: Check for fuel leaks, if any are found, correct before use. Contact an authorized
service center if necessary.
Engine Oil Tank
Engine oil level
CAUTION: Running the engine with insufficient oil can cause
serious engine damage. Be sure to check the engine on a level surface
with the engine stopped.
1. Remove the oil filler cap (A) and check the oil level: it should reach the
top of the oil filler neck (B).
2. If the level is low, fill to the top (C) of the oil filler neck with the
recommended oil.
Add the engine oil slowly to avoid overflowing, as the engine oil tank
capacity is small.
Every 10 hours, check the engine oil level and replenish oil up to the top
of the oil filler neck if the engine is operated for more than 10 hours
continuously.
Use 4-stroke, or an equivalent high detergent, premium quality motor oil
certified to meet or exceed U.S. automobile manufacturer's requirements
for service classifications SG, SF. Motor oils classified SG, SF will show
this designation on the container. SAE10W-30 is recommended for
general, all temperature use.
CAUTION: Using nondetergent oil or 2-stroke engine oil could
shorten the engine's service life.
The recommended operating temperature range is –5 °C to 40 °C.
Before starting the engine, make sure that the blade is free to move and is not in contact with any
foreign objects.
The cutting attachment must not rotate when the engine is idling. Otherwise contact an authorized
service center for verification and repair.
WARNING: Hold the brush cutter firmly with both hands. Always keep
your body on the left side of the tube. Never use a cross-handed grip.
Left-handers should follow these instructions too.
Keep a proper cutting position.
Over exposure to vibrations can result in blood-vessel or nerve injury to
persons suffering of blood circulation problems.
Seek medical attention if you experience physical symptoms such
numbness, lack of feeling, decrease of normal strength, changes in the
colour of the skin. These symptoms normally appear in the fingers, hands or
wrists.
Before starting the engine, make sure that the throttle lever works freely.
WARNING: Follow safety instruction for fuel handling. Always shut off the engine before refuelling.
Never add fuel to a machine with a running or hot engine. Move at least 3 m from the refuelling site
before starting engine. DO NOT SMOKE!
1. Clean surface around the fuel cap to prevent contamination.
2. Slowly loosen the fuel cap.
3. Carefully pour the fuel into the tank. Avoid spillage.
4. Prior to replacing the fuel cap, clean and inspect the gasket.
5. Immediately replace the fuel cap and hand tighten. Wipe up any fuel spillage.
13