Starting The Engine; Breaking-In The Engine; Stopping The Engine - AGT 2835 PR Bedienungsanleitung

WARNING: Check for fuel leaks, if any are found, correct before use. Contact a service center if
necessary.
Engine is Flooded
- Set the on/off switch to STOP.
- Unscrew the screw (1) on the cover.
- Remove the cover (2).
- Engage a suitable tool in the spark plug boot (3).
- Pry off the spark plug boot.
- Unscrew and dry off the spark plug.
- Open wide the throttle.
- Pull the starter rope several times to clear the combustion chamber.
- Refit the spark plug and connect the spark plug boot, press it down firmly,
reassemble the other parts.
- Set the on/off switch to ON, the starting position.
- Set the choke lever to OPEN position – even if engine is cold.
- Now start the engine.

STARTING THE ENGINE

Fill the carburetor by pushing primer bulb (A).
Put the ON/OFF switch (11) in the ON position. Pull
the throttle lever (13) and stop it at half-throttle by pressing the button (14),
then release the lever (13).
Put the choke lever (D) in the CLOSE position. Place the brush cutter on
the ground in a stable position.
Check that the blade is free. Holding the brush cutter down, pull the
starting rope slowly until you meet resistance. Then pull it hard several
times, and when the engine starts put the choke lever (D) back into its
original position OPEN.
Repeat until the engine starts. Once the engine has started, press
throttle trigger (13) to release it from the half-throttle position and let the
engine idle.
WARNING: Once the engine is warmed up do not use the choke
to start up again.
WARNING: Use the semi-acceleration device only in the phase of
starting a cold engine.

BREAKING-IN THE ENGINE

The engine reaches the maximum power after 5÷8 hours of activity.
During this period of breaking-in do not use the engine at wide open
throttle without load, to avoid excessive functioning stress.
WARNING! - During the breaking-in period do not vary the combustion
to obtain a presumed power increase; the engine can be damaged.
NOTE: It is normal for smoke to come off from a new engine during and
after its first use.

STOPPING THE ENGINE

Set the throttle lever to idle position (13) and wait a few seconds to let the
engine cool off .
Turn off the engine, putting the ON/OFF switch (11) in the STOP position.
14