Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GBR
CANCELLING AND DELETING
DATAS
To perform the last action, or cancel the current measure-
ment process, press CLR (clear) button / OFF (9).
MEASUREMENT PROCESS
A. Press to display during the operation, the button for
measurement process (3) for the last 20 readings.
B. To exit the measurement process, press CLR button
(clear) / OFF (9).
REFERENCE POINT SETTING
At each turning on of the device, the reference point is the
standard right margin. You can change the measurement
reference point by pressing the key (10) in the peak and
distance measurement points. To use the distance piece,
use the lower part of the meter ( see Figure D, page 5). Each
time you will hear a signal. The selecetd measurement refe-
rence point is displayed on the screen (1), in the upper left
corner, as follows: This setting is not stored in the device
memory, so use this function if necessary, after turning on
again the device.
190
ERROR AND TROUBLESHOOTING MESSAGES
Error message on the screen
Possible cause
204
Miscalculation
208
Miscalculation of excessive current flow.
220
Discarged batteries / battery
252
Hight temperature
253
Low temperature
255
Poor signal or measurement time due to
low reflection surface
256
Strong signal due to high reflexion surface
261
The target is too far
500
Hardware damage
Problem solve
Repeat the measurement process.
Contact the dealer.
Change the batteries.
The meter will be cool down, for example, in
a cool room. The outer temperature must be
between 0 °C to + 40 °C
The rangefinder will be heated, for example
storage in a warm room. The outer temperature
must be between 0 °C to + 40 °C
Increase the degree of reflexion, for example
with a white paper in the measurement point.
A dark colour paper decrese the reflexion degree
The measurement can be carried out within 40
meters.
Try repeatedly to turn on and off the
rangefinder. If the error message persists, there
is a damage. Please contact your dealer.
191
GBR
Werbung
Kapitel
Fehlerbehebung
