On / Off Backlight; Changing The Units Of Measurement; Adding And Substracting Measurement Values - bahag WISENT Bedienungsanleitung

GBR
triangle is displayed in the left side, in the centre.
C. Aim the laser beam at the first point of measurement
and then press MEAS (measurement) / key (12) to
perform the first distance measurement. Repeate the
procedure to perform the second distance measurement.
The results of the two measurements and the result in
meters are dispalyed on the screen (1).
D. When concluding the measurement press the CLR
(clear) button / Off (9) for two seconds to stop the
measurement device.
Indirect measurement of distance – with
three points
A. Press MEAS (measurement) / key (12) to turn on the
rangefinder.
B. Press four times to activate the key for area selection to
measure the indirect distance (11). Display (1) two adjacent
triangles are displayed in the left side, in the centre.
C. Aim the laser beam at the first point of measurement
and then press MEAS (measurement) / key (12) to
perform the first distance measurement. Repeate the
procedure to perform the second and the third distance
measurement. The results of the three measurements
and the result are dispalyed in meters on the screen (1).
D. When concluding the measurement press the CLR
(clear) button / Off (9) for two seconds to stop the
measurement device.
188

ON / OFF BACKLIGHT

To activate or deactivate screen light, use Uit (units)
button (4). The device is not storing in the memory
this information so use this function when necessary
and renew it after turning on the device.
CHANGING THE UNITS OF
MEASUREMENT
To set different units, press and maintain Unit key
(units) (4). Meter (m), feet (ft) and inches (in) and foot
and inch (' ") are available.
ADDING AND SUBSTRACTING
MEASUREMENT VALUES
A. Press MEAS (measurement) / key 12 to turn on the
rangefinder.
B. Aim the intended measurement point and press again
MEAS (measurement) / key 12 to measure the distance.
Now you have two options:
C1. Pressing once add – (+) / substract (-) button (2)
the next measurement value will be added to the first
measured value (plus) you will see a symbol + on the
screen (1).
C2. Pressing shortly add – (+) / substract (-) button (2) the
next measurement value will be substracted to the first
measured value (plus) you will see a symbol 0 - on the
screen (1).
D. Pressing MEAS (measurement) / key (12) a conti-
nous distance measurement is conducted, then (1) the
result occurs on the screen.
189
GBR