Introduction; Meaning Of Symbols; Intended Use - bahag WISENT Bedienungsanleitung

GBR

INTRODUCTION

Please carefully read the instructions
i
before using this measurement device
and acquaint yourselves with the operation of the
measurement device. This manual contains important
information for operation and security instructions. The
failure to comply with security and operation inst-
ructions might lead to product damage. This manual
grounds on the European standards and norms into
force. If neccesary, these may be overalpped with the
guidelines and the laws from other countries, specific
for each country. Keep these operation instructions
safe and communicate them to third parties.

MEANING OF SYMBOLS

Text note. Please note and read.
i
WARNING! This symbol and
!
WARNING!
signal indicates a significant
potential danger which might lead to death or serious
injuries.
ATTENTION! This symbol and
! ATTENTION !
signal indicates a danger which
might lead to slight accidents.
NOTE! This symbol and signal in-
NOTE !
dicates a potential risk of material
damages.
178
This symbol indicates that the device complies
with the relevant safety standards.
Class laser, with a 630-670 nm
wavelenght and in accordance with
DIN EN 60825-1: 2007. Do not look
LASER RADIATION! DON'T LOOK
DIRECTLY INTO THE LASER BEAM.
CLASS 2 LASER, < 1mW, 630-670
directly into the light beam of the
nm EN 60825-1:2007
measurement device and do not use other optical instru-
ments when using this device. The above mentioned in-
formation agrees with the warning label from the device.

INTENDED USE

The device is exclusively designed in order to measure
the wood and buildings humidity, such as concrete,
plaster or morter, building or woods, paper and card-
board. It is designed only for personal use. The com-
mercial use is strictly excluded! This device is not a toy.
The device may be used only as stated by this manual,
any other use shall be considered innapropriate. The in-
napropriate use might lead to material damage and/or
personal injuries. The manufacturer and/or distributor
shall not be responsible for the damage resulted from
misuse or innapropriate use.
179
GBR