Key Of Device / Functions; Use Of Measurement Functions - bahag WISENT Bedienungsanleitung

GBR
Due to environmental influences, for example,
i
the sun light or a reflexion might damage the
measuring range and the measuring precision.
Please use the enclosed targets for a more
i
precise measurement.
Switching the laser on or off
A. Press the MEAS (measurement) key / on (12) to turn
on the rangefinder. An audible signal and the flashing
display (1) indicate that the device is on. The laser beam is
already displayed in the position adressed by the device.
B. To turn off the rangefinder, press for approximately two
seconds CLR key (clear) / (Off key) (9). An audible signal
indicates that the device is off, simoultaneosly, the laser
beam stops. After approximately three minutes without
using the rangefinder, this will automatically turn off.

KEY OF DEVICE / FUNCTIONS

The following functions might be performed with the
help of the keys of device:
- Turning on the rangefinder (press)
- Distance measuring (key 12)
- Setting the measuring option
(area selection) (key 11)
- Measuring the distance in progress (key 17)
184
USE OF MEASUREMENT
- Addition and substraction (values additi-
on and substraction) (key 2)
FUNCTIONS
-Displaying the measurement result curve
(key 3)
- Selection of measurement reference
point (distance piece, back margin of
device, front margin of device)
- Turning on / off the display light
Simple measurement of distance
- Unit of measurement button (to change
A. Press MEAS (measurement) / key (12) to turn on the
the unit of measurement – press) (key 4)
rangefinder.
B. Aim the measurement point and press MEAS (mea-
- Deleting from measurement curve
surement) / key (12) again to measure the distance.
(each key press, the last value measured
is eliminated) (key 9)
The result of measurement is displayed directly on the
- Turning off the measurement device
screen (1) and the laser beam stops.
(press)
185
GBR
Indication!
After measuring the distance, the laser beam
stops automatically for security. In order to turn
on the laser beam, press MEAS (measurement) /
key (12) again.