Gmini GM1604 Bedienungsanleitung Seite 33

7) STEP - SAFETY BELTS
REMOVING THE SAFETY BELTS
24. The safety belts can be removed (for the reason of washing or for use in the deep pram configuration).
If you want to remove the belts, it is necessary to draw the buckle of the crotch strap and to pull it out of the
opening in the seat outwards, then draw the buckles of the shoulder straps and pull them out of the openings in
the backrest outwards.
Pull the abdominal straps out in the same way (it is necessary to rotate the anchoring buckle to vertical position,
otherwise it will not pass through the opening).
After removing the safety belts, make sure that during new installation they have been properly pulled through
the anchorage points again. When attaching the clamping systems anew, carefully follow the procedure
described below:
Pull the buckle through the opening for the crotch strap. Make sure that the whole buckle goes through the
opening and the central buckle of the belt is turned towards you.
Then pull the buckle of the shoulder strap through the backrest opening and secure it, repeat the same
procedure also with the second shoulder strap, as well as with the two abdominal straps.
WARNING: After completing the installation,
the belts must be readapted to your child's figure.
25. . The pram is equipped with a rear brake lever located on the pram
If you want to brake the pram, press the lever downwards using your
The wheels are released by pushing the lever upwards.
WARNING: Whenever you stop, use the brake! Never depart from the
pram when standing on a slope and a child is seated in it, even if the
WARNING: After using the brake lever, check whether the brakes are
The pram is equipped with a pre-installed five-point safety belt,
consisting of two shoulder straps, two abdominal straps and a belt
between the child's legs with a buckle.
WARNING: It is possible to adjust the belts so that they could adapt
to the child's figure!
Place the child into the pram. Fasten the belts: first slide the buckle
of the right shoulder strap onto the central buckle and secure it with
the right lumbar strap, repeat the same action also on the left side.
Adjust the height of the shoulder straps so that they fit tightly to the
child's body and arms. Then adjust the width of the lumbar straps so
that they fit your child's body.
If you want to undo the abdominal strap, press the button of the
central buckle to release all parts of the belt.
WARNING: Always use safety belts! To ensure the safety of your
child, use all five points of the safety belt fastening!
8) STEP - REAR BRAKE
wheels are braked!
properly secured on both rear wheels!
rear axis.
foot.