Grease Filter; Charcoal Filter (Filter Version Only); Replacing Lamps - Elica Glide Montage- Und Gebrauchsanweisung

Grease filter

This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Fig. 9

Charcoal filter (filter version only)

It absorbs unpleasant odours caused by cooking.
The saturation of the activated charcoal occurs after more or
less prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths (or when the filter saturation indication
system – if envisaged on the model in possession – indicates
this necessity).
Fig. 10
1. Slide out the vapour collector.
2. Remove the grease filter.
3. If the carbon filter is already mounted and requires
replacement, depress the unblocking key S and remove
the filter downward.
4. Remount the grease filter.
If the carbon filter is not mounted:
1. Slide out the vapour collector.
2. Remove the grease filter.
3. Insert the carbon filter in the upper hooks T and fix it
using the lower hooks S.
4. Remount the grease filter.

Replacing lamps

Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Model with halogen light bulbs.
Use a small screwdriver to act as a lever on the border of
the light bulb housing in order to remove the light bulb.
Replace the light bulb with a new 12V 20W 30° Ø35
GU4.
Carry out the replacement and the mounting of the new
light bulb following the procedure in reverse.
Model with incandescent light bulbs:
Remove the vapour screen.
Remove the grease filter, it will then be possible to
access the bulb housing area.
Unscrew the damaged light bulb and replace it with a
new 40W max (E14 - B35) light bulb.
Model with PL light bulb.
Remove the vapour screen.
Remove the grease filter, it will then be possible to
access the bulb housing area.
Extract the damaged light bulb and replace it with a new
9W-G23 (Cooker hood with two light bulbs) or 11W-G23
(Cooker hood with one light bulb).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
13