▶ Make sure that the batteries suffer no mechanical damage.
▶ Do not charge or continue to use damaged batteries (e.g. batteries with cracks, broken parts, bent or
pushed-in and/or pulled-out contacts).
2.3
Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a battery charger for Hilti Li-Ion batteries with a rated voltage of 7.2 to 36 volts.
It is designed to be connected to power outlets providing an AC (alternating current) voltage of 100 to 240
volts (depending on country-specific version).
The C4-36-DC charger can be connected to a 12 volt or 24 volt DC electric supply socket in a motor vehicle.
A list of the batteries approved for use with this product can be found at the end of this document.
3.3
Information displayed
3.3.1
Information displayed by the charger and battery
Display
LED lights constantly.
Blinking.
12
English
Printed: 21.06.2018 | Doc-Nr: PUB / 5069440 / 000 / 11
1
On the battery
Indication of state of charge.
Charging is in progress.
Release button with additional function (state
@
of charge display activation)
Battery
;
Battery state of charge LED indicators
=
Indicator LED
%
Battery interface
&
2
On the charger
The charger is connected and
ready for operation.
The battery is too hot or too
cold.
2024461
*2024461*