Maintenance - maruyama MS0735W(CE) Bedienungsanleitung

Maintenance

Cleaning, maintenance and draining
For cleaning, check and maintenance, always be
sure to stop machine.
Check and maintenance items
for each season
Cleaning of air cleaner
・When elements become dirty or clogged,
reduced performance or difficulty starting is
observed. Clean the elements regularly to
remove dirt and prevent clogging.
・When cleaning the element, wash it using gaso-
line, dip it in the blended fuel used and install it
after squeezing it hard to remove excess fuel.
1
Disassembly
2
Clean
3
Squeeze
Cleaning ignition plug
・Remove car-
bon, and adjust
the clearance
to 0.6-0.7mm.
English
Gasoline
Squeeze
hard
Dip in the
blended fuel
0.6~0.7mm
Remove
carbon
Pump
Check for worn piston packing and seal packing,
and replace worn one with new one.
※ For disassembly and maintenance, consult with
the sales outlet where you purchased the prod-
uct or sales office.
Drain
CAUTION
Make sure to drain, otherwise the pump might be
damaged by freezing in winter.
①Remove drain cap of chemical tank and hose
connecting screw of pump to drain residual liquid.
②Put fresh water into the chemical tank, start
the engine, spray from the nozzle to clean the
pump and inside of the hose.
③Operate for 15-20 seconds to drain residual
liquid at the throttle lever position, which is a
little bit back from full open position.
④Set throttle lever at low speed, and stop the
engine with the stop button.
9
Hose contacting screw
Drain cap