Conrad Electronic 75 06 84 Bedienungsanleitung Seite 21

Servicing
The devices are maintenance-free. For this reason, you should never open it. If you
do open it, the warranty will lapse.
The outside of the devices should be cleaned with a clean dry cloth or brush only.
Do not use cleaning agents which contain carbon, petrol, alcohol or
similar substances for cleaning purposes. The surface of the devices
can be corroded by these. Moreover, the vapours are detrimental to
health and explosive. Nor should sharp-edged tools such as screwdri-
vers, metal brushes etc. be used for cleaning purposes.
Disposal
If the receiver system no longer functions or cannot be repaired, it must be disposed
of in accordance with the relevant statutory regulations.
Troubleshooting
In purchasing the receiver system, you have acquired a product which has been
designed to the state of the art and is operationally reliable.
However, problems and malfunctions may still occur.
For this reason, we wish to describe to you here how you can eliminate possible dis-
turbances yourself.
Always observe the safety instructions!
26
Scope of delivery
Radio receiver with aerial
Plug-in power unit
AV cinch cable
Operating instructions
Setting up the device
Set up the receiver in the vicinity of the surveillance monitor or TV set but not direct-
ly on the surveillance monitor. This could interfere with the transmission.
The most favourable location is approx. 1-2 m above the floor (better reception con-
ditions).
There must be a mains socket in the vicinity of the reception location.
Connecting the radio receiver
Monitor terminal
• Connect the AV cable as depicted to
a suitable monitor or TV system with
an AV cinch input and the receiver
(white/red plug = audio (tone in
mono), yellow plug = video).
• Connect the small voltage plug of the
power unit (7) to the voltage supply
jack of the receiver (4).
Pay attention to the correct output
voltage of 12 V DC!.
• Insert the plug-in power unit into a
suitable mains socket.
• The camera is now ready for use.
23