Philips LTC 2009/61 Anleitung Seite 48

1 DESCRIPTION
These kits are designed to mount the following monitors in a
standard EIA 19-inch rack using either Universal or Wide
Spacing.
Rack Kit Monitor Model
LTC 9113/00 LTC 2813/90, & LTC 2914/91
LTC 9114/00 LTC 2814/90
LTC 9115/00 LTC 2915/90
LTC 9017/00 LTC 2017/50 & LTC 2017/60
LTC 9117/00 LTC 2917/91
2 UNPACKING
Unpack carefully. This is mechanical equipment and should be
handled with care.
Check for the following items:
(1) Base Tray
(2) Rack Sides
(1) Cover Bezel
(1) Hardware Kit
(4) 4-40 Machine Screws (Cover Bezel)
(6) 8-32 Machine Screws (Rack Sides)
(4) 10-32 Machine Screws (Rack Installation)
(4) 10-32 U-type Nut Fasteners (Rack Installation)
If an item appears to have been damaged in shipment, replace it
properly in its carton and notify the shipper. If any items are
missing, notify your Philips CSI Sales Representative or Customer
Service Representative.
The shipping carton is the safest container in which the unit
may be transported. Save it for possible future use.
3 SERVICE
If the unit ever needs repair service, the customer should contact
the nearest Philips CSI Service Center for authorization to return
and shipping instructions.
Service Centers
U.S.A. & Canada: 800-366-2283
Mexico & Central America: 52-5-564-2726
Europe & Middle East: 011-32-1-440-0711
South America: 54-11-4956-0837
Asia Pacific Region: 011-65-481-4422
4 INSTALLATION
4.1 Assembly
Tools Required
Small Phillips screwdriver.
Assembly
1. Position the monitor so that it is upside down, with its feet
(where applicable) on top and the front of the monitor
towards you. Remove and retain each replacement foot and
mounting screw from the monitor. Now, install the base
tray onto the monitor with the flat side of the base tray
towards the monitor; the edges of the base tray should face
up. The square hole of the base tray should now be at the
lower left edge of the tray. Align the removable foot
mounting holes with the appropriate holes in the base tray.
Secure the monitor to the base tray using the reserved
mounting screws from the removable feet.
Orientation Hole
Removable
Feet
Figure 1 Installing Base Tray
NOTE: If the monitor does not have removable feet, as
with the LTC 2917/90 and LTC 2813/60 monitors, align
the pads on the monitor base with the holes in the base tray
and secure the monitor to the base with sheet metal screws
(not provided); self-threading sheet metal screws with a
maximum length of 19 mm (3/4-inch) are recommended.
While attaching monitor to base tray, do not push in the
plastic stand-offs protruding from the bottom of the
monitor, as this may damage the monitor's internal
workings.
NOTE: When installing the LTC 9113/00, use the front-
most set of holes in the base tray so that the flip-down
drawer on the monitor is still accessible once installed in the
rack.
2. Align the two (2) rack side panels with the sides of the base
tray, and attach using the six (6) supplied 8-32 screws.
Figure 2 Attaching Side Panels
2