Cv Programming - Märklin 24802 Bedienungsanleitung

8. CV Programming

CV programming must be done on the programming track.
We recommend creating a fictitious locomotive for pro-
gramming purposes. Values in parentheses are the factory
settings.
The turnout lantern connected to the digital installation
decoder will blink as a control check during the data
transmission.
fx (MM)
Before doing any programming, the turnout to be program-
med must be switched with the Keyboard. After that the CVs
are changed immediately with the Control Unit or the CV
configuration on the Central Station. After that the program-
med turnout is to be switched again with the Keyboard. At
this point the programming is accepted and is functional.
CV Meaning
8 Decoder reset
36 Turnout lantern
off/on
The procedure for programming with the 6021 Control Unit is
the same as locomotive programming (www.maerklin.de ->
Tools & Downloads -> Technische Informationen).
Values
8 (-) factory setting, not
written value is
0-1 (1)
DCC
CV Meaning
1 Address, lower value
Byte
7 Manufacturer version
number (software
version)
8 Manufacture recogniti-
on ID Decoder reset
9 Address, higher value
Byte
29 Configuration
Bits 0-4 are not used
Bit 5: Decoder type
Bit 6: Addressing
method
Bit 7: Decoder type
36 Turnout lantern, off/on 0-1 (1)
Setting and generating addresses larger than 255:
Example: Address 1044 -> 1044:256=4,078125 . The value be-
fore the comma (4) is to be entered in CV 9. The value after
the comma (0,078125) is multiplied by 256, 078125x256=20.
The value of 20 that is generated must be entered in CV 1.
Values
0-255
(-) read only
(131) read only,
8 (-) factory setting, value
is not written
0-7 (0)
(192) read only
0
0 / 32 basic or advanced
accessory decoder
decoder or output
0 / 64
address
128 accessory decoder
9