Important Notes; Programming - Märklin 76371 Bedienungsanleitung

Durch erneutes Drücken der Taste „Stop" die Stromversor-
gung wieder einschalten.
Im aktiven Programmiermodus blinken nun Signalbilder im
Wechsel. Drücken Sie nun das Signalbild des eingerichteten
Lichtsignals auf dem Keyboard der Central Station.
76391: Hp1
Bei einem mehrbegriffi gen Signal blinken anschließend
weitere Signalbilder im Wechsel. Die einzelnen Schritte
entnehmen Sie den nachfolgenden Beispielen.
76394:
HP1 => Sh1
76371: Sh1
76372: Sh1
76393:
HP1 => HP2

Important Notes

• WARNING! Sharp edges and points required for opera-
tion.
• http://www.maerklin.com/en/imprint.html
The H0 color light signals from this electronic series offer
the following features:
• All home signals consist of a signal control module the
signal mast that goes with it.
• These signals can be operated conventionally (6646/66470
transformer, 72720 control box) or digitally (example: with
6040 Keyboard, Central Station, Mobile Station 60653). No
additional decoder is required when operating the signals
digitally.
• The change in the signal aspects happens prototypically
with a gentle changeover.
• When the signal is set at "slow", the operator is responsi-
ble for adjusting the speed of the train.
• The signal control module can only be used to control
signals from the Märklin series that belong to it.
Programming the scale color light signals
! No locomotives may be run during the programming
procedure. Please note that the programming procedure
will be stopped if there are no entries made within 30
seconds. Set up on your Keyboard beforehand the the scale
color light Signal to be programmed. Enter the switching
time at 1,000 millise-conds for the programming procedure.
Now click on this symbol
comeafterward.
and confi rm the messages that
7