Dust/Chip Extraction - Bosch GEX Professional 125-150 AVE Originalbetriebsanleitung

Material
– Paint
– Varnish
– Filler
– Bodyfiller
Expert for Wood
– All wood and wood-based ma-
terials (e.g. hardwood, soft-
wood, chipboard, construction
boards)
Best for Wood
– Hardwood
– Chipboard
– Construction boards
– Metal materials
– Car paint
– Stone
– Marble
– Granite
– Ceramic
– Glass
– Perspex
– Fibreglass reinforced plastics
Changing the sanding sheet (see figure A)
To remove the sanding sheet (10), lift it from the side and
pull it from the sanding pad (8).
Remove dirt and dust from the sanding pad (8), e.g. with a
paintbrush, before attaching a new sanding sheet.
The surface of the sanding pad (8) is fitted with a hook-and-
loop fastening, allowing sanding sheets with a similar back-
ing to be secured quickly and easily.
Press the sanding sheet (10) firmly onto the underside of
the sanding pad (8).
To ensure optimum dust extraction, make sure that the
punched holes in the sanding sheet are aligned with the
drilled holes in the sanding pad.
Selection of the Sanding Plate
The power tool can be fitted with sanding pads of various
hardnesses, depending on the application:
– Extra soft sanding pad: Suitable for polishing and sensit-
ive sanding even on curved surfaces.
– Soft sanding pad: Suitable for all sanding work, universal
application.
– Hard sanding pad: Suitable for heavy sanding on flat sur-
faces.
Bosch Power Tools
Application
For sanding down paint
For sanding undercoats (e.g. removing brush-
strokes, paint drips and paint runs)
For final sanding of primers prior to painting
For pre-sanding, e.g. of rough and uneven
beams and boards
For surface sanding and levelling of slight irreg-
ularities
For finish-sanding and fine sanding of wood
For pre-sanding
For shaping and edge chamfering
For fine sanding during shaping
Buffing and edge rounding
Changing the sanding pad (see figure B)
Note: Replace damaged sanding pads (8) immediately.
Remove the sanding sheet or polishing tool. Unscrew the
screw completely (11) and remove the sanding pad (8). At-
tach the new sanding pad (8) and retighten the screw.
Note: When attaching the sanding pad, make sure that the
teeth of the catch mate with the recesses in the sanding pad.
Note: Damaged sanding pads must only be replaced by an
after-sales service centre authorised to work with Bosch
power tools.

Dust/chip extraction

The dust from materials such as lead paint, some types of
wood, minerals and metal can be harmful to human health.
Touching or breathing in this dust can trigger allergic reac-
tions and/or cause respiratory illnesses in the user or in
people in the near vicinity.
Certain dusts, such as oak or beech dust, are classified as
carcinogenic, especially in conjunction with wood treatment
additives (chromate, wood preservative). Materials contain-
ing asbestos may only be machined by specialists.
– Use a dust extraction system that is suitable for the ma-
terial wherever possible.
English | 15
Grit
Coarse 40
60
Medium 80
100
120
Fine 180
240
320
400
Coarse 40
60
Medium 80
100
120
Fine 180
240
320
400
Coarse 80
Medium 100
120
Fine 180
240
320
400
Very fine 600
1200
1 609 92A 49A | (17.05.2018)