Siemens HKW-600 Bedienungsanleitung Seite 7

Connect the
§C§
vehicle electrical system so that
12V+ or 24 V+ are applied when
the ignition is switched on.
Only use spade fuse connectors
for connecting the cable and then in-
sert 3A spade fuses
fuse connectors
To safeguard the wiring loom profes-
sionally, the fuses must be mounted
between the end of the wiring loom
supplied and the connector from the
vehicle.
Connecting the loudspeaker cable to
the wiring loom
Connect the white/black loud-
speaker cable +
green/black
§E§
nection using a cable
9
connector .
Connect the black loudspeaker
cable to the green loud-
§H§
speaker cable
9
connector .
line (violet) to the
5
into the spade
4
.
to the
§G§
loudspeaker con-
using a cable
§F§
Car Kit Bluetooth (en)
Connecting the radio*
The Car Kit can be connected to
your car's audio system via the
phone-in connection of your car
radio. The loudspeakers of the
4
audio system are then used as a
play-back system for the Car Kit.
Please use the optional phone-in
adapter cable to ensure an opti-
mal connection to the radio.
Connect the connector cable
of the wiring loom
phone-in connection of your car
radio via the optional phone-in
adapter.
Then connect the connector ca-
ble
§G§
ducting pole of the phone-in
connection of your car radio.
If the voltage levels of the Car Kit
and phone-in connection differ,
the voltage levels can be adjust-
ed with the phone-in adapter
cable.
* For vehicles with car radios with
phone-in connections. The car radio
is not included in the Siemens
standard scope of supply.
3
directly to the signal-con-
5
§H§
to the