Changing batteries
1. Remove the end cap
is pointing towards the "Open" marking on the appliance. Then lift off the end cap
①
cap
2. Open the battery compartment
②
compartment
.
3. Remove any old batteries if already inserted.
4. Insert the new batteries onto the lid of the battery compartment in accordance with the stated polarity.
5. Close the battery compartment
6. Place the end cap
"Open" marking. Then turn the end cap
①
The end cap
is now firmly attached to the appliance again.
Removing foil
1. Use the foil cutter
closed wine bottle.
2. Firmly press the foil cutter
wine bottle cannot fall, hold it firmly with your other hand.
3. Now rotate the wine bottle by 360 degrees. This process may need to be repeated multiple time until
you can remove the foil by pulling it upwards.
4. Remove the foil that has been cut from the bottle.
Removing a cork
1. Firmly hold the wine bottle again with one hand so that it cannot fall. Now firmly place the appliance
onto the wine bottle until the tip of the spiral
2. Press and hold down the ▼ button
cork out of the neck of the bottle. Continue to maintain a tight hold on the wine bottle and the
appliance during this process.
3. Only let go of the ▼ button
4. Remove the appliance from the wine bottle again and hold it so that the opening is pointing down-
wards. Then press the ▲ button
5. Let go of the▲ button
Please Note:
•
You can also use the foil cutter
the top of the foil cutter
•
Do not use the appliance to remove any corks from sparkling wine bottles. These corks
could get caught in the appliance and cause damage.
CLEANING AND MAINTENANCE
ATTENTION! Never use alcohol, acetone, benzene or
any other aggressive cleaning agents to clean the
appliance. Do not use hard brushes or metal objects.
ATTENTION! Switch the appliance off before cleaning
and remove the batteries from the battery compartment.
This appliance is maintenance-free.
①
from the battery compartment
②
by pulling the latch
②
so that the latch
①
onto the appliance so that the arrow on the end cap
④
to cut off the foil over the cork. To do this, place the foil cutter
④
together using your thumb and index finger. In order to ensure that the
⑥
. The spiral
⑥
when the cork has been fully removed from the neck of the bottle.
⑦
. The cork will now be unscrewed from the inside of the appliance.
⑦
as soon as the cork falls out of the appliance.
④
as a stand. Simply place the appliance into the recess on
④
.
②
by turning it so that the arrow on the end
③
towards you to unlock the battery
③
clicks into place.
so that the arrow is pointing towards the "Close" marking.
①
⑤
penetrates into the cork.
⑤
will be screwed into the cork and then pull the
G
①
.
①
is pointing towards the
④
onto the