Scope Of Supply; Correct Use; Safety Instructions - Conrad Electronic Zalman ST-300BLP Bedienungsanleitung

Introduction
Dear Customer,
Thank you for purchasing this power supply unit.
This product is EMC tested and meets the requirements of Directive
89/336/EEC. It therefore also meets the requirements of the applicable Euro-
pean and national directives. Proof of CE conformity has been established and
the corresponding declarations are obtainable from the manufacturer.
To maintain this status and ensure safe operation, you as the user must comply with
these operating instructions.
All company and product names mentioned in this document are registered
trademarks. All rights reserved.
In case of questions, consult our technical information service
Germany: Tel. 0180/5 31 21 16 or 09604/40 88 47
Fax 09604/40 88 44
e-mail: tkb@conrad.de
Mon - Fri 8.00 to 18.00
Austria: Tel. 0 72 42/20 30 60 · Fax 0 72 42/20 30 66
e-mail: support@conrad.at
Mon - Thu 8.00 to 17.00
Fri. 8.00 to 14.00
Switzerland: Tel. 0848/80 12 88 · Fax 0848/80 12 89
e-mail: support@conrad.ch
Mon - Thu 8.00 to 12.00, 13.00 to 17.00
Fri 8.00 to 12.00

Correct use

The ATX switched-mode power supply unit is intended for installation in a suitable
ATX PC housing.
From there it supplies PC components such as the motherboard, the hard disk, the
CD-ROM etc. with power.
The motherboard must have an ATX power port.
Due to its high capacity (max. 300W - please note the technical data) it can also be
used to supply power to large PCs with numerous expansions.
16
Use other than that described above will lead to damage to the product and addi-
tional risks, such as short circuit, fire, electric shock etc. No part of the product may
be changed or modified. The housing must not be opened. The labels on the product
must not be damaged or removed and none of the product's screws or attachments
must be loosened or removed.
Contents

1 Scope of supply.................................................................................................17

2. Safety instructions.............................................................................................17

3. Functional description .......................................................................................18
4. Control elements and connections....................................................................19
5. Installation .........................................................................................................20
6. Handling ............................................................................................................22
7. Maintenance and cleaning ................................................................................22
8. Disposal.............................................................................................................24
9. Rectifying faults .................................................................................................24
10.Technical data ..................................................................................................25
11.Connector pin assignment ................................................................................25
12.Hints and tips ....................................................................................................27
1. Scope of supply
• Power supply unit
• Mains cable
• Operating instructions
2. Safety instructions
Damage due to non-compliance with these operating instructions
renders the warranty void.
We do not accept liability for consequential damage.
Page
17