Stopwatch - Hanhart COMPACT 2 Bedienungsanleitung

Characteristics of Compact 2
- Countdown with acoustic signal, stopwatch in count-up, LCD watch
- 6 LCD digits for hours minutes and seconds
- Automatic function as stopwatch after elapsed countdown
- Countdown
Maximal display: 23 h, 59 min., 59 sec.,
measuring unit: 1 sec.
- Memory for countdown (recall of pre-set time)
- Acoustic signal during 1 minute when pre-set time is elapsed
- Separate programming buttons for hours, minutes and seconds
- Sizes: 64 x 60 x 16 mm
- Weight: about 40 g (with battery)
Fixation by means of the clip (illustration)
This stopwatch can be fixed on thin objects like the front pocket of a
shirt.
Fixation by means of the magnet (illustration)
This stopwatch can be fixed on iron or steel surfaces with its magnet on
the backside.
Fixation by means of the stand (illustration)
This stopwatch can be set up on tables by folding out the clip on the
backside.
Battery servicing (see illustration)
By turning the round screw-plate on the backside with a coin in the
direction of the arrow, change battery (11.5 V, G-131), positive element
'+' on top. Replace the screw-plate by turning in the opposite direction
of the arrow.
Countdown
Switch button TIMER/CLOCK on position TIMER. Depress button RESET. Dis-
play shows 00:00 00 and TIMER.
1. Pre-setting of hours:
Depress button HR until desired figure is displayed. Digits are chan-
ging by each pressure and signalized by an acoustic beep. By keeping
the button HR depressed, digits are moving faster without acoustic
signal.
2. Pre-setting of minutes:
Same procedure, but with button MIN.
3. Pre-setting of seconds:
Same procedure, but with button SEC.
Start/stop
1. Once the desired time is pre-set, depress button START/STOP.
Countdown is started on seconds' rhythm.
2. At any moment, it is possible to interrupt and restart the countdown
by depressing button START/STOP.
Alarm
1. Once the pre-set time is elapsed, an acoustic signal is buzzing 1
minute long. The sign TIMES-UP is displayed.
The timer is then changing in function 'stopwatch'.
2. Alarm and stopwatch can be stopped by depressing the following
buttons: HR - MIN – SEC - START/STOP - RESET.
Memory for countdown
1. Once the buzzer is switched off, it is possible to recall the pre-set
time by depressing the button START/STOP. The sign MEMORY is then
displayed.
2. By depressing again the button START/STOP the countdown is
reactivated. The sign MEMORY disappears.

Stopwatch

1. Depress button RESET for setting display to zero.
2. Depress button START/STOP for starting the time measurement at
seconds' rhythm.
3. The count-up can be interrupted and restarted as often as
requested by pressing the button START/STOP.
Pre-setting of normal time
1. Select function ‚normal time' by positioning the switch TIMER/CLOCK
on CLOCK. The normal time is then displayed and is to be recognized
by a double point blinking on display.